FAQ Search Results
Is saw dust from a Woodmizer bandsaw mill from green logs considered "wet"? And thus is this system not able to handle that?
How does the airlock rotate? How fast?
If there is any water in the application, we do not recommend our product. The airlock rotates 13 rpm rotation for less seal wear.
What is the collection efficiency for the 4" Super Dust Deputy on wood particulates less than 10 microns?
We do not measure that small of micron with cyclonic separation. It will filter 99% of all visible dust/chips from the airstream.
Will this bin work with the Super Dust Deputy #AXD002040A? Does the built in lid of the cyclone fit this container?
The only drum compatible with the 4" Super Dust Deputy is the 15 gallon dust bin. The 15 gallon lid is not the same diameter as any of our other drums.
Which is the correct HEPA Cartridge filter to purchase to replace the filter from my 5HP Dust Gorilla Pro cyclone?
You would want FCS183600HF for the HEPA filter.
What is the overall assembled height?
The height of this unit is approximately 64"
What is the floor space required for the V-1500 w/ 35 gallon drum?
On the floor, the V-System's stand is a 30" x 30" square. How wide the overall system is depends on the orientation of your filter plenum.
If the plenum is oriented ninety degrees clockwise from the system's inlet, then the overall width would be 47". Please refer to the owner's manual for more detailed dimensions.
Can the V-System be used with a smaller dust bin to lower the total height?
With the stand, the V-System's overall height cannot be lower than 87" (for 1.5HP) or 88" (for 3HP). Oneida Air Systems does offer wall-mounting brackets for the V-System. This would allow you to mount the V-System dust collector at a lower height for use with smaller containers.
Please note that you may have to empty the smaller drum much more frequently depending on your workflow.
I have an older dust collector that was purchased years ago. Would the Stacking Sound Filter work on my unit?
Yes, the Stacking Sound filter will work with your older system, but you may need a small amount of extra hardware to install it.
Some of the filters on our older dust collectors (2008 and older) had a threaded rod running down inside the filters, with a plate at the bottom that the filters rested on. You will need to extend this rod by purchasing an additional length and a rod coupler from your local hardware store.
When purchasing a unit for an older system, take care to measure the diameter of your dust collector's filter and the space available below the fine dust bin at the bottom of the filter. You'll want to purchase a sound filter that matches the diameter of your cartridge filter (13" or 18") and has sufficient room below the filter stack (1" taller than the sound filter itself) to allow for installation. The Stacking Sound Filters are not recommended for systems that have the cartridge filter installed in a horizontal orientation.
Will this lid fit on a steel drum that isn't from Oneida Air Systems?
Drums can vary significantly by manufacturer, even with similarly listed dimensions. For that reason, we can only recommend our products be used interchangeably with other Oneida Air Systems components.
I’d like to purchase the 55 gallon fiber drum only. I don’t need the kit is this possible?
Yes. You can find the individual components (drum, clamp, and lids) at oneida-air.com/dust-collectors/system-components/containers/components.
Did you find what you were looking for?
Categories: