FAQ Search Results

Raw dust collection hose can be coupled using our Male-Male Ducting Adapters with minimal loss of airflow performance. The adapters should be secured in place using hose clamps.

Remove old filter and clean sealing surface on lid. Carefully slide opening of filter over cage. Push bottom of filter firmly down until it seats on the filter post. Place enclosed rubber washer on the threaded post. Secure filter in place with existing filter nut. Do not over tighten. Do not use filter plate supplied with vac. Click "Read More" for important safety information.

We realize that this can sometimes be tough to fit the hose onto these ports. We have found that the quickest and easiest way is to pull it on using pliers, one side at a time, until the hose is covering the port by 1" to 2". Then use the hose clamps provided with the drum kit to secure the hose in place for good.

The hardware (gasket, nuts, bolts,etc.) is stored in between the two buckets included in the kit. 

No you do not need to remove the internal foam filter. These "drop-in" foam silencers that are included with the cartridge filters of our older dust collection systems can be used in conjunction with the Stacking Sound Filters.

Our urethane flex hose can be cut to size using a razor knife and diagonal cutters to through the clear lining and reinforcing metal wire (respectively).

Create pipe lengths by starting at the crimped end and snapping the two sides together. Hold together with one hand and move down the pipe as the seam snaps in. When you get halfway, it should snap fully closed. Click "Read More" for further instructions and images.

No. Whether you're installing the duct yourself or installing for a customer, Oneida Air Systems' Quick-Clamp Duct is simple enough for anyone to use.

You'll want to apply the tape so that all three openings on the cyclone are connected by a continuous, conductive path. When doing so, make sure that the tape is wrapped over the edge of the cyclone's ports and that it overlaps the bolt hole on the cyclone's bottom flange. Click "Read More" for further instructions and images.

Industrial, spiral pipe components are raw on both ends. The simplest way to connect them is to use our Spiral Pipe Adapters; crimped on both ends, these fittings slip into each raw pipe and can be secured in place using machine screws or pop rivets.