FAQ Search Results

The Dust Deputy 2.5 Cyclone has a larger diameter inlet and outlet to increase flow, and a larger overall size to reduce friction relative to the volume of air passing through. Less friction means less pressure drop and increased flow.

Under normal operation conditions only the finest dust will get past the high-efficiency cyclone to the filter. The Filter can be cleaned easily with the Pulse Cleaning lever. This takes less than a minute. Pulse down the with the Pulse Cleaning lever frequently or after every use. Pulsing (reverse air) removes the fine dust from the filter. It will keep your system‘s airflow at an optimal performance level.
Upset condition: If the dust bin is overfilled and the filter pleats get packed with sawdust, the filter must be removed for manual cleaning.

Create pipe lengths by starting at the crimped end and snapping the two sides together. Hold together with one hand and move down the pipe as the seam snaps in. When you get halfway, it should snap fully closed. Click "Read More" for further instructions and images.

Yes. For inside edge routing the lower chip cover can be easily detached (no tools necessary) allowing the bit to sink in completely while waste is removed from above the bit.

No. In our effort to make the router hood as universal as possible, inexpensive, easy to use, and effectively collect dust, we were unable to incorporate the use of guide bushings.

No. Whether you're installing the duct yourself or installing for a customer, Oneida Air Systems' Quick-Clamp Duct is simple enough for anyone to use.

You'll want to apply the tape so that all three openings on the cyclone are connected by a continuous, conductive path. When doing so, make sure that the tape is wrapped over the edge of the cyclone's ports and that it overlaps the bolt hole on the cyclone's bottom flange. Click "Read More" for further instructions and images.

No. There is a small section near the lock of the clamp where there are no holes. This portion has no holes because that is as far as the clamp can contract.

Yes, but not on our website. Please contact our sales department at (800) 732-4065 or by email at [email protected].

Industrial, spiral pipe components are raw on both ends. The simplest way to connect them is to use our Spiral Pipe Adapters; crimped on both ends, these fittings slip into each raw pipe and can be secured in place using machine screws or pop rivets.